|Posted on September 4, 2013 at 8:10 AM|
Tuesday 3rd August 2013
Today we cut the hardboard for the templates to be used for driling the screw holes in the floor joists and plates. We had to use a handsaw in the end as the knife, which should have been able to cut through the hardboard, just wouldn't.
We also cut some of the hardboard for the internal floor to go on top of the OSB.
Lastly we clamped an Avionics Tower together to see if we'd have enough room to crawl through it into the avionics bay maintainance area. Fortunately we do but we'll probably put some handles on the inside to assist with standing up as the crawlspace will be quite tight.
Photo shows tower outer frame in temporary cramps.
Categories: Sim Construction